Sprocket 16B-1 z=50 with hub

Product Description

Sprocket 16B-1 z=50, with hub

Sprocket 16B-1, simplex, with 50 teeth and a hub - pitch 1" (25.4 mm). Compliance with DIN 8187 / ISO 606 guarantees full interchangeability with a chain of the same pitch; the sprocket is made of C45E steel (EN 10083-1) in a non-hardened version - the standard choice for applications with moderate and medium load.

Technical data

Frequently asked questions

Can a sprocket with a technological bore be installed without additional machining?

No - the technological bore is deliberately too small to fit a typical shaft. It must be bored on a lathe to the required diameter and, if necessary, a keyway cut according to the requirements of the specific machine.

How should a chain drive be lubricated to extend its service life?

The lubricant should get between the rollers and plates of the chain, not just onto its outer surface - it is best applied to the lower (slack) part of the chain, just before it runs onto the sprocket. In a dusty environment, a thick grease works better, while at high speeds a lower-viscosity oil that penetrates the joints more easily is preferable.

Can I replace a simplex sprocket with a duplex one without changing the other drive components?

No - switching to a duplex chain and sprocket requires replacing the entire set (the sprockets on both sides of the drive and the chain) with a duplex version of the same pitch, because the rim spacing and chain width differ from those of the simplex version.

What causes premature wear of the side faces of the teeth?

This is most often the result of misalignment of the sprockets on the shafts (so-called lateral runout of the drive). The chain does not run straight, and its inner plates catch on the sides of the teeth, wearing them down to bare metal. The system must be realigned immediately.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.