Sprocket 16B-1 z=35 with hub

Product Description

Sprocket 16B-1 z=35, with hub

Sprocket 16B-1, simplex, with 35 teeth and a hub - pitch 1" (25.4 mm). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

How should a chain drive be lubricated to extend its service life?

The lubricant should get between the rollers and plates of the chain, not just onto its outer surface - it is best applied to the lower (slack) part of the chain, just before it runs onto the sprocket. In a dusty environment, a thick grease works better, while at high speeds a lower-viscosity oil that penetrates the joints more easily is preferable.

What happens when a sprocket operates under a greater load than intended?

Overloading first accelerates normal tooth wear, and with sudden overloads (e.g. machine blockage) the teeth may become permanently bent or sheared. In such cases, using an overload clutch in the system is often a better solution than choosing an oversized sprocket "just in case".

What is the set screw hole in the hub for?

The threaded hole in the hub is used to screw in a headless screw (a so-called grub screw). It secures the sprocket against axial displacement along the shaft during machine vibration.

Does the difference in hardness between sprocket and chain affect their rate of wear?

Yes - chain and sprocket manufacturers select hardness so that they wear as evenly as possible, rather than one element "cutting down" the other. An excessively hard sprocket working with a soft, non-certified chain (or vice versa) leads to faster wear of the weaker element.

Where is this product used?

Typical applications of the 16B-1 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.