Sprocket 16B-1 z=29 with hub

Product Description

Sprocket 16B-1 z=29, with hub

Sprocket 16B-1 with hub, 29 teeth, simplex - a product matched to chain with a pitch of 25.4 mm (1"). The sprocket complies with DIN 8187 / ISO 606 and is made of C45E steel (EN 10083-1); the teeth are not hardened, which lowers the cost of the sprocket and makes it easier to machine (e.g. deep boring of the hub) throughout the entire volume of the material.

Technical data

Frequently asked questions

Can I replace a simplex sprocket with a duplex one without changing the other drive components?

No - switching to a duplex chain and sprocket requires replacing the entire set (the sprockets on both sides of the drive and the chain) with a duplex version of the same pitch, because the rim spacing and chain width differ from those of the simplex version.

How should a chain drive be lubricated to extend its service life?

The lubricant should get between the rollers and plates of the chain, not just onto its outer surface - it is best applied to the lower (slack) part of the chain, just before it runs onto the sprocket. In a dusty environment, a thick grease works better, while at high speeds a lower-viscosity oil that penetrates the joints more easily is preferable.

How do you select the number of teeth on the driving and driven sprockets to obtain the required ratio?

The ratio is calculated as the quotient of the number of teeth on the driven sprocket and the number of teeth on the driving sprocket. For example, to halve the rotational speed, the driven sprocket should have twice as many teeth as the driving sprocket - both sprockets must have the same pitch and number of strands.

Do a newly fitted chain and sprocket require running-in after installation?

After installation, it is worth running the drive for a while without full load, observing the smoothness of operation and the bearing temperature - this allows installation errors (e.g. misalignment) to be detected before full load is applied. The tooth profile of the sprocket itself does not require running-in if the sprocket and chain have matching pitch and are made in accordance with the standard.

Where is this product used?

16B-1 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.