Sprocket 12B-3 z=14 with hub

Product Description

Sprocket 12B-3 z=14, with hub

The sprocket 12B-3 shown is a triplex (three-strand) sprocket with 14 teeth, made with a hub, for chain with a pitch of 3/4" / 19.05 mm. Compliance with DIN 8187 / ISO 606 guarantees full interchangeability with a chain of the same pitch; the sprocket is made of C45E steel (EN 10083-1) in a non-hardened version - the standard choice for applications with moderate and medium load.

Technical data

Frequently asked questions

What does uneven, one-sided wear of the sprocket teeth indicate?

This usually indicates misalignment between the driving and driven sprockets or that the chain is skewed relative to the sprocket. It is worth checking the alignment of both sprockets and the condition of the shaft bearings - over time, one-sided wear causes the chain to jump off the tooth.

How important is the concentricity of the hub bore relative to the toothed rim?

If the hub bore is not machined concentrically with the toothed rim, the sprocket will "run out" during operation - the teeth will engage the chain at a varying angle, which accelerates their wear and generates additional vibration. That is why boring out the pilot bore must be done on a lathe, clamping the sprocket by the hub or rim, and not "by eye".

How do I check the radial and axial runout of a sprocket after mounting it on the shaft?

A dial indicator on a magnetic stand is used for the measurement. Place the tip against the circumference of the sprocket or its side face, rotate the shaft and check the deviations. Excessive runout indicates faulty installation or a damaged shaft.

How do I select a sprocket with bearing for a tensioning system?

An idler sprocket (with built-in bearing) is selected according to the pitch of the working chain and mounted on the slack side (not on the tight side). It is important that the bearing is protected against dust, especially in agricultural machinery.

Where is this product used?

12B-3 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.