Sprocket 12B-2 z=35 with hub, hardened

Product Description

Sprocket 12B-2 z=35, hardened hub

The sprocket 12B-2 presented here is a duplex sprocket with 35 teeth, made with a hardened hub, for a chain with a pitch of 3/4" / 19.05 mm. The material is carbon steel C45E (EN 10083-1), and the teeth undergo induction hardening to 45-55 HRC - in accordance with DIN 8187 / ISO 606; the hub retains a lower core hardness, so it can be machined safely.

Technical data

Frequently asked questions

How does induction hardening of the teeth affect abrasion resistance?

Induction hardening hardens only the surface layer of the tooth, where the chain rollers bear. The tooth is resistant to wear, while the sprocket core and hub remain elastic enough to safely absorb impacts and be suitable for boring.

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. If the sprocket has hardened teeth, the hub is usually soft and easy to machine.

In what cases are multi-strand sprockets used?

They are used to drive multi-strand chains in heavily loaded machines where there is no room for a wider sprocket with a larger pitch. Several strands distribute the load evenly, preventing premature chain breakage.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

12B-2 sprockets are used in industrial drive transmissions: conveyors, feeders, packaging machines and production lines where precise, repeatable torque transmission matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.