Sprocket 10B-2 z=28 with hub, hardened

Product Description

Sprocket 10B-2 z=28, hardened hub

Sprocket 10B-2 (pitch 5/8" - 15.875 mm), duplex, 28 teeth, with hardened hub. The material is carbon steel C45E (EN 10083-1), and the teeth undergo induction hardening to 45-55 HRC - in accordance with DIN 8187 / ISO 606; the hub retains a lower core hardness, so it can be machined safely.

Technical data

Frequently asked questions

Why are cast sprockets less precise than turned and milled ones?

Cheap castings have a rough tooth surface, hidden air bubbles and slight deformations. CNC-turned and milled sprockets mean a smooth working surface, perfect alignment and safety for the most expensive machines.

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

In what cases are multi-strand sprockets used?

They are used to drive multi-strand chains in heavily loaded machines where there is no room for a wider sprocket with a larger pitch. Several strands distribute the load evenly, preventing premature chain breakage.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

Typical applications of the 10B-2 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.