Sprocket 10B-2 z=12 with hub, hardened

Product Description

Sprocket 10B-2 z=12, hardened hub

The sprocket 10B-2 presented here is a duplex sprocket with 12 teeth, made with a hardened hub, for a chain with a pitch of 5/8" / 15.875 mm. Compliance with DIN 8187 / ISO 606 guarantees full interchangeability with chain of the same pitch; C45E steel (EN 10083-1) and induction hardening of the teeth (45-55 HRC) provide high wear resistance while keeping the hub machinable.

Technical data

Frequently asked questions

Can a sprocket be welded directly to the drive shaft?

Technically this is possible, but we strongly advise against such a solution. Welding overheats the material, damages nearby bearings, bends the shaft and prevents the worn sprocket from being easily replaced later. Always use mounting with a key or a clamping bush.

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

When is it worth considering a sprocket made of reinforced steel for heavy-duty operating conditions?

In heavy dust, with powerful jolts (e.g. in presses) and where a breakdown in the middle of the season cannot be afforded, sprockets made of higher-strength quenched and tempered steel are often a good solution - it is worth consulting the supplier about unusual operating conditions.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

Applications include drives in the food industry, packaging machines, sorting lines and agricultural harvesting machines, where the sprocket operates seasonally but under full load.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.