Sprocket 06B-3 z=9 with hub

Product Description

Sprocket 06B-3 z=9, with hub

Sprocket 06B-3 with hub, 9 teeth, triplex (three-strand) - a product matched to chain with a pitch of 9.53 mm (3/8"). Compliance with DIN 8187 / ISO 606 guarantees full interchangeability with a chain of the same pitch; the sprocket is made of C45E steel (EN 10083-1) in a non-hardened version - the standard choice for applications with moderate and medium load.

Technical data

Frequently asked questions

How important is the concentricity of the hub bore relative to the toothed rim?

If the hub bore is not machined concentrically with the toothed rim, the sprocket will "run out" during operation - the teeth will engage the chain at a varying angle, which accelerates their wear and generates additional vibration. That is why boring out the pilot bore must be done on a lathe, clamping the sprocket by the hub or rim, and not "by eye".

How does rotational speed affect the selection of the minimum number of teeth of a sprocket in the system?

At higher rotational speeds, a larger minimum number of teeth on the smallest sprocket in the system is recommended to reduce chain vibration and impacts resulting from the so-called polygon effect. With very small sprockets (e.g. 9-11 teeth) and high speeds, wear and vibration levels increase significantly faster than with larger sprockets.

Is it worth using guards on sprockets and the entire drive?

Yes - a guard protects operators from contact with moving parts and at the same time limits the ingress of dust and moisture to the chain, which genuinely extends its service life. In many industrial machines, a chain drive guard is also an occupational safety requirement.

How can you check that the sprocket meshes correctly with the chain when the machine is started for the first time?

At low speed (e.g. turning the shaft by hand), it is worth observing whether the chain enters and leaves the teeth smoothly around the entire circumference of the sprocket, without catching or jumping. Any irregularities in operation at this stage usually indicate an alignment error rather than a defect in the sprocket itself.

Where is this product used?

Typical applications of the 06B-3 sprocket: drives for pumps, mixers and industrial fans, as well as control systems for industrial gates and roller shutters, where resistance to continuous operation is required.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.