Sprocket 06B-3 z=45 with hub, Cast iron

Product Description

Sprocket 06B-3 z=45, with cast iron hub

The sprocket 06B-3 shown is a triplex (three-strand) sprocket with 45 teeth, made with a hub, for chain with a pitch of 3/8" / 9.53 mm. The material is grey cast iron - an economical solution with good vibration damping that proves itself in drives running at constant speed; the hub has a pilot bore that must be bored out individually to suit the shaft.

Technical data

Frequently asked questions

Can a sprocket be welded directly to the drive shaft?

Technically this is possible, but we strongly advise against such a solution. Welding overheats the material, damages nearby bearings, bends the shaft and prevents the worn sprocket from being easily replaced later. Always use mounting with a key or a clamping bush.

How does rotational speed affect the selection of the minimum number of teeth of a sprocket in the system?

At higher rotational speeds, a larger minimum number of teeth on the smallest sprocket in the system is recommended to reduce chain vibration and impacts resulting from the so-called polygon effect. With very small sprockets (e.g. 9-11 teeth) and high speeds, wear and vibration levels increase significantly faster than with larger sprockets.

What is the relationship between the number of teeth of a sprocket and the rotational speed of the drive?

This is the basic principle of the transmission ratio. If there is a small sprocket on the motor (drive) and a large one on the machine, the machine will turn more slowly but gain proportionally greater torque (force).

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. The hub is usually soft and easy to machine, even in the version with hardened teeth.

Does a cast iron sprocket require a different chain than a steel sprocket of the same pitch?

No - the tooth geometry and pitch are identical to those of the steel version of the same size, so the cast iron sprocket works with the same chain. The difference lies in the material of the hub and rim: cast iron dampens vibrations better and is cheaper, but withstands impacts and operation at high rotational speeds less well than steel.

Where is this product used?

Applications include drives in the food industry, packaging machines, sorting lines and agricultural harvesting machines, where the sprocket operates seasonally but under full load.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.