Sprocket 06B-2 z=20 with hub, hardened

Product Description

Sprocket 06B-2 z=20, hardened hub

Sprocket 06B-2, duplex, with 20 teeth and a hardened hub - pitch 3/8" (9.525 mm). As a European manufacturer, Ozdowski supplies the sprocket in C45E steel (EN 10083-1), in accordance with DIN 8187 / ISO 606 - the teeth are induction hardened (45-55 HRC), while the hub remains soft and easy to machine.

Technical data

Frequently asked questions

What material is this sprocket made of?

As standard, it is carbon steel C45E (EN 10083-1) - a good material for typical industrial applications, providing a good balance between strength and machinability of the hub.

How do I check the radial and axial runout of a sprocket after mounting it on the shaft?

A dial indicator on a magnetic stand is used for the measurement. Place the tip against the circumference of the sprocket or its side face, rotate the shaft and check the deviations. Excessive runout indicates faulty installation or a damaged shaft.

What causes premature wear of the side faces of the teeth?

This is most often the result of misalignment of the sprockets on the shafts (so-called lateral runout of the drive). The chain does not run straight, and its inner plates catch on the sides of the teeth, wearing them down to bare metal. The system must be realigned immediately.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

06B-2 sprockets operate in the drives of construction machinery, goods lifts, aggregate conveyors and woodworking machines - wherever tooth durability under heavy load matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.