Sprocket 06B-2 z=15 with hub, hardened

Product Description

Sprocket 06B-2 z=15, hardened hub

Sprocket 06B-2 with hardened hub, 15 teeth, duplex - a product matched to a chain with a pitch of 9.525 mm (3/8"). Made in accordance with DIN 8187 / ISO 606, from C45E steel (EN 10083-1), with teeth induction hardened to 45-55 HRC - as a Polish manufacturer, Ozdowski ensures that the hub remains soft and suitable for turning.

Technical data

Frequently asked questions

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. If the sprocket has hardened teeth, the hub is usually soft and easy to machine.

What causes premature wear of the side faces of the teeth?

This is most often the result of misalignment of the sprockets on the shafts (so-called lateral runout of the drive). The chain does not run straight, and its inner plates catch on the sides of the teeth, wearing them down to bare metal. The system must be realigned immediately.

How do you cut a keyway in the hub of a sprocket?

We cut keyways precisely on slotting machines according to DIN 6885. If you do it yourself, maintain axial alignment and the correct width and depth of the keyway so that the key sits securely and is not sheared off.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

This type of sprocket is used in drives of agricultural and industrial machinery, including screw and bucket conveyors, feed conveyors, packaging machines and internal transport systems.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.