Sprocket 06B-2 z=11 with hub, hardened

Product Description

Sprocket 06B-2 z=11, hardened hub

Sprocket 06B-2, duplex, with 11 teeth and a hardened hub - pitch 3/8" (9.525 mm). Sprocket compliant with DIN 8187 / ISO 606, milled from C45E steel (EN 10083-1); the teeth are induction hardened (45-55 HRC), while the core and hub remain soft, allowing the bore to be safely machined to the shaft size.

Technical data

Frequently asked questions

How do I bore the hole in a sprocket to fit a motor shaft?

A sprocket with a pilot bore should be clamped in a lathe (gripping the hub to avoid runout) and bored to the required diameter with an H7 tolerance. If the sprocket has hardened teeth, the hub is usually soft and easy to machine.

What forces act on the key in a sprocket and how can it be prevented from shearing?

The key transmits the entire shearing torque between the shaft and the sprocket. Make sure it is made of suitable quenched and tempered steel, has an accurate fit in the keyway and that the machine is not subjected to extreme jerks without an overload clutch.

How does a hardness of around 45-55 HRC on the teeth extend the service life of the sprocket-chain system?

A hardness of 45-55 HRC matched to the hardened chain rollers is the optimal combination. The sprocket and chain wear slowly and evenly, and the sprocket does not turn into a "blade" that could shear the chain during operation.

Is a duplex sprocket the same as a tandem sprocket (for two single chains)?

No, even though they look very similar. A tandem sprocket is also a single, monolithic sprocket, but with a different (wider) spacing of the toothed rims - designed specifically for two independent simplex chains running in parallel. This duplex sprocket has a rim spacing matched to a single duplex chain, in which both strands are integrated with each other. Using a duplex sprocket for two single chains is a mistake - the spacing is too narrow and the chains will rub against each other, which leads to accelerated wear and, in extreme cases, to serious drive failure.

Where is this product used?

06B-2 sprockets operate in the drives of construction machinery, goods lifts, aggregate conveyors and woodworking machines - wherever tooth durability under heavy load matters.

When placing your order, please check the current stock level of this gear - the lead time depends on it and is clearly stated according to the quantity available in the given warehouse.

Product photos are for illustrative purposes only.